SYSMEX KX-21 - Page 258

INSTRUMENT SETUP
Sysmex KX-21 Operator’s Manual -- Revised October 1998 10-5
2) Language Setting
Set the language for displaying on the screen. The language can be selected from
the three kinds listed below:
Settings Display language
Japanese Japanese
English English
Chinese Chinese
Table 10-2-3: Language Setting
3) Parameter Name Setting
Set WBC analysis parameter names. The parameter can be selected from the
following two kinds:
Settings Analysis Parameter Name
W-SCR W-SCR
W-MCR
W-LCR
W-SCC
W-MCC
W-LCC
LYM% LYM%
MXD%
NEUT%
LYM#
MXD#
NEUT#
Table 10-2-4: Parameter Name Setting
4) RDW Setting
Set the RDW calculation method. The RDW calculation method can be selected
from the following two kinds:
Settings RDW Calculation Method
RDW-SD RDW-SD
RDW-CV RDW-CV
Table 10-2-5: RDW Setting
NOTE: • The settings of system setup become valid from the next time you turn
ON the instrument power.