INSTRUMENT SETUP
10-6 Sysmex KX-21 Operator’s Manual -- Revised October 1998
(9) When the setting of each parameter is completed, press [SELECT] key. The Setting
Change Confirmation message appears.
Change? Cont. Set Cancel
Figure 10-2-3: Setting Change Confirmation Message
(10) Using[ ] or [ ] key, move the cursor to select "Cont.," "Set," or "Cancel."
[Cont.]: Returns to the System Setup screen. And the setting operation can be
continued.
[Set]: Updates the settings and returns to the Analysis screen.
[Cancel]: Cancels the changed settings and returns to the Analysis screen.
(11) Press [ENTER] to execute the selected process.
NOTE: • When you change the system setup, always turn OFF then ON the
power. Until you do this, the changed contents of the settings will not
be reflected.
To Next Page
Loading...
