INTRODUCTION
1-10 Sysmex KX-21 Operator’s Manual -- Revised October 1998
Display Message Meaning
*
Change Mode
*
Please wait.
The whole blood mode is turning into the pre-
diluted mode, or the pre-diluted mode is
turning into the whole blood mode.
No.123457 WB
Aspirating
The sample is being aspirated in whole blood
mode analysis.
No.123457 PD
Aspirating
The sample is being aspirated in pre-diluted
mode analysis.
No.123457 WB
Analyzing
Samples are being aspirated, diluted, and
counted in whole blood mode (or pre-diluted
mode).
No.123457 WB
Rinsing
Hydraulic line in the whole blood mode (or
pre-diluted mode) is being rinsed.
No.123457 WB
Not Ready
Replenish Diluent
An error occurs, making analysis impossible.
(When an error occurs, the error message
appears in reversed display in the right upper
area of the LCD screen.)
No.123457 WB
Not Ready
PU Sleeping
When operation has been suspended over
15 minutes, the compressor power is turned
OFF and this message is displayed. Press
the [START] switch to get ready for analysis.
Momentary power failure occurred.
When the power is turned off without making
shutdown process or when power outage
caused the instrument to stop, this message
appears when the unit is started next time.
WB
Ready
*
When data is automatically output to the host
computer, " * " mark lights up in the right
upper corner of the screen. This applies only
when an optional serial interface is
incorporated.
To Next Page
Loading...
