DISPLAY AND PROCESSING OF ANALYSIS RESULTS
Sysmex KX-21 Operator’s Manual -- Revised October 1998 3-17
3.6 Correcting a Sample Number
Use the [SAMPLE No.] key to correct a sample number of analysis data.
(1) Use the underline cursor to select the desired analysis data, then press the [SAMPLE
No.] key. The selected sample number will be highlighted.
(2) Use the numeric keypad to enter a new sample number, then press the [ENTER] key.
(3) When the confirmation message appears, select the [Set] button.
To Next Page
Loading...
