SYSMEX KX-21 - Page 85

DISPLAY AND PROCESSING OF ANALYSIS RESULTS
3-16 Sysmex KX-21 Operator’s Manual -- Revised October 1998
3.4 Printing
This menu allows the marked analysis data to be printed by the built-in printer.
Execution of Printing
(1) Using the underline cursor, specify the analysis data you want to print and press
[ENTER] key. This puts the mark on the analysis data.
(2) Press [2] key to select "2: Print." The built-in printer starts printing the marked
analysis data.
NOTE: • For print format, refer to Chapter 2, Section 5.2: Printin
g
of Anal
y
sis
Result
.
• In printin
g
stored data, T
y
pe 2 print is performed even when T
y
pe 1
print format is selected.
(
Particle distribution is not printed.
)
3.5 HC Output (Option)
This menu allows outputting the marked analysis data to the host computer, if an optional
serial interface is incorporated.
NOTE: • "3: HC Output" on the Menu is displa
y
ed onl
y
when the optional serial
interface is incorporated.
Execution of HC Output
(1) Using the underline cursor, specify the analysis data you want to output to the host
computer and press [ENTER] key. This puts the mark on the analysis data.
(2) Press [3] key to select "3: HC Output."
Analysis data is output to the host computer in the order of marking.
During output to the host computer, the * mark blinks at the right top edge of the
system status display area.
*
Stored Data
*
*
Figure 3-3-7: Screen during Output to Host
NOTE: • Output to the host computer cannot be interrupted.
Sysmex KX-21 Operator’s Manual -- Revised January 2000