SYSMEX KX-21 - Page 95

MAINTENANCE AND SUPPLIES REPLACEMENT
4-8 Sysmex KX-21 Operator’s Manual -- Revised October 1998
(5) Make sure no contaminants remain, then wipe off water.
(6) Re-mount the SRV tray to the original state.
• After mounting the tray, make sure the probe fixing screw is not loose.
If analysis is made with the screw loosened, air can enter the system
and affect the data.
CAUTION: • Mount the SRV tray properly as to the face/bottom and the direction.
(7) Close the front cover of the main unit.
CAUTION