Installation and Commissioning
22 sysmik.de Manual SCA-340 / SCA-340-L
The 10/100BaseT-Ports are able to recognize and to correct an interchanged
receive path pair (RD+/RD-). Thus either crossover or patch cable can be used, no
matter if the remote station is another end device, a switch or a hub.
Note: The maximum distance of 100 m between Ethernet devices can only be achieved
using cables from category 5 on.
3.2.5 USB-OTG for local Access
The local access is a connection between Scalibur and a PC, which works
regardless of the device settings (especially IP address). Simply connect a Windows
PC to the Scalibur with a standard Mini USB cable.
Installation of PC driver
With Scalibur Operating System 1.01.0 or newer, the PC driver software is
automatically installed (Windows 8.1, Windows 10).
For older Scalibur Operating Systems or when using Windows 7, the proper driver
has to be selected manually as follows:
If you connect the Scalibur to your PC for the first time, Windows detects a new
device and shows this in the Device Manager as “RNDIS/Ethernet Gadget” below
“Other devices”.
1
select “Update driver software…” in the local menu of the device entry
chose “Browse my computer for driver software”
chose “Let me pick from a list of device drivers on my computer”
select “Network adapters” as device type
select “Microsoft Corporation” as manufacturer and “Remote NDIS
Compatible Device” as network adapter and click “Next”
pass warning “Update driver warning” with “Yes”
close the notification window after successful device driver installation
1
If the device is detected as a serial COM device instead, we recommend a firmware
upgrade of the Scalibur. If that is not feasible, please contact SysMik for an alternative
solution of the driver installation.
To Next Page
Loading...