EC900 Series Operation Manual V4.7
14.3 Determining the installed Comms Port.
When running the software for the first time you need to determine what the comms port is that has
been assigned to the instrument. Note for multiple instruments connected simultaneously each will
have a different comms port allocation. In addition to this you should bear in mind that Comms
Comms Utility can only access up to Com 6.
Ensure that the supplied or similar USB Cable is connected between the Computer and the analyzer.
1. Click on “Start”, “Control Panel” and “System” you should be presented with the following
screen.
2. Click on “Hardware” and “Device Manager” again you should see a screen similar to this.
To Next Page
Loading...