EC900 Series Operation Manual V4.7
1.1 Important
Please read this manual before attempting to install or operate the equipment.
The equipment should be electrically connected and grounded in accordance with the instructions
attached to the power cord and in accordance with good standard practice.
No responsibility is accepted by Systech Illinois
for accidents resulting from improper use of this equipment.
All service and technical enquiries are covered from our factories in Thame, Oxfordshire, and
Johnsburg, Illinois where we will endeavour to give a quick and helpful response to all queries.
The factory addresses are:
Illinois Instruments, Inc (U.S.)
2401 Hiller Ridge Road,
Johnsburg
Illinois IL 60051
Tel: +1 815 344 6212
Systech Instruments Ltd
17 Thame Park Business Centre
Wenman Road
Thame
Oxfordshire
OX9 3XA Tel: +44 (0) 1844 216838
For customers outside UK or USA, please contact us for details of your local representative.
Alternatively check out our website:
www.systechillinois.com
To Next Page
Loading...