Need help?Do you have a question about the SystemAir NaviPad and is the answer not in the manual?
General| Brand | SystemAir |
|---|---|
| Model | NaviPad |
| Category | Control Panel |
| Language | English |
Defines Danger, Warning, Caution, and Important notes regarding potential hazards.
Warning to disconnect all supply circuits before accessing terminals for safety.
Warning to disconnect supply circuits before accessing terminals.
Introduction to Systemair's 7" capacitive touch screen user interface.
Steps involved in calibrating and setting up the NaviPad wizard.
Summary of the air handling unit's current operational status.
Explanation of the various symbols used within the NaviPad interface.
Details on actions and read/write privileges for end users.
Defines read/write privileges for operator mode, excluding configuration.
Outlines full read and write privileges available in service mode.
Step-by-step instructions for logging in with service mode password.
Guide on utilizing the wizard for common configurations and allocations.
Overview of accessible controller settings and menus.
Access to operation overview, I/O status, temperature, and fan control.
Displays active signals, I/O, and operational modes like temperature and airflow.
Provides a comprehensive overview of sensors, I/O, and device status.
Settings for temperature limits, setpoints, and outdoor temperature values.
Example demonstrating how to adjust the supply air temperature setpoint.
Settings for fan speed, compensation curves, and start delay.
Visual representation of the unit's current operational status with real-time values.
Configuration options for date, time, operating schedules, and holidays.
Example illustrating how to set the normal fan speed schedule.
Example illustrating how to set the low fan speed schedule.
Overview of system settings and configuration parameters.
Guidance on using the wizard for accessory and function configuration.
Steps for activating and configuring specific unit functions.
Mandatory safety step: disconnect mains power before any maintenance.
Awareness of rotating parts, sharp edges, and hot surfaces during maintenance.
Procedure for changing the internal battery in the CU27-C control unit.
Cautionary notes on ESD protection and cable connector positions.
To Next Page
