Figure 6.15
"Timer" is used to set the timed on/off state of indoor unit.
• press (Function) button to switch to the "Timer" function. When the indoor unit is on, first
complete the "Timer Off" settings, and then the "Timer On" settings. When the indoor unit
is off, first complete the "Timer On" settings, then the "Timer Off" settings.
• When the indoor unit is off:
1) "Timer On" setting: press (Function) button to go to the "Timer On" setting, the display
will show "0.0h Time On", and the words "Time On" will blink, then press (Confirm)
button to go to the timer setting. Press ▲ and ▼ buttons to adjust the time, and press
(Confirm) button to complete the timer setting (see Figure 6.16).
4-5-6 Timer
• When the "Follow Me" functions of wired and remote controllers are turned on at the
same time, the "Follow Me" function priority is assigned to the wired controller.
21
Note:
The "Follow Me" function of the wired controller is on by default, and its icon lights up when
the function is on.
1) Turn off "Follow Me": Press (Swing) and (Confirm) buttons at the same time, and
hold for 5 seconds to turn off the "Follow Me" function, and its icon disappear.
2) Turn on "Follow Me": When the "Follow Me" function is off, Press (Swing) and
(Confirm) buttons at the same time, and hold for 5 seconds to start the "Follow Me"
function again, and display its icon " " (see Figure 6.15).
Press at the same
time and hold for 5 seconds
To Next Page
Loading...
Need help?
General
