SystemAir SysCoil Comfort SCC10 - 8 Hydraulic Connections; Operating Face; Coil Water Volume

English
The fan-coil units may contain a small amount of oil incompatible with plastic polyethylene piping
(PER/HTA/PVC). The coil should be rinsed out before use to avoid any problem.
It is the installer’s responsibility to contact their pipe supplier and take into account the general
instructions for the use of plastic pipes (PER/HTA/PVC).
Caution
OPERATING FACE
8 SysCoil Comfort
2. Withdraw the four screws that hold the casing attached to the two chassis anks.
8. HYDRAULIC CONNECTIONS
8.1. OPERATING FACE
The operating face of Left/Right
versions is dened in relation
to the position of the hydraulic
connections when the unit is
viewed facing the operator.
Note: In the example below, the
operating face is on the right.
Size SCC10 SCC20 SCC30 SCC40 SCC50 SCC60 SCC70 SCC80
2 pipes L
0.41 0.61 0.89 1.17 1.45 1.73 2.19 2.60
4 pipes
L
0.41 0.61 0.89 1.17 1.45 1.73 2.19 2.60
L
0.20 0.20 0.30 0.39 0.48 0.58 0.73 0.92
8.2. COIL WATER VOLUME
3. Then, lift the casing vertically by pulling its
forwards. Place it carefully to one side.