SystemAir SYSCROLL 20-30 Air EVO HP - Clock Settings and Alarm List

25
English
6 - Control
6.3.3 Clock Menu
Set clock time and date; set time tables (day by day, up to four different timings each day).
6.4 Alarm list
CODE DESCRIPTION
0 NO ALARM PRESENT
1
Temperature probe Returning water Broken
or disconnected
2
Temperature probe Leaving water Broken
or disconnected
3 Temperature probe Coil Broken or disconnected
4
Temperature probe Outdoor air Broken
or disconnected
5
Temperature probe Exhaust gas Broken
or disconnected
6
Pressure transducer Discharge Broken
or disconnected
7 Pressure transducer Suction Broken or disconnected
8 Temperature probe Suction Broken or disconnected
13 Flow switch Water
14 Flow switch Water (Repeated)
15 Pressure switch Suction
16 Pressure switch Suction (Repeated)
17 Low delta Suction
18 Low delta Suction (Repeated)
19 Thermal Fan 1
20 Thermal Fan 1 (Repeated)
21 Thermal Fan 2
22 Thermal Fan 2 (Repeated)
23 Clock
24 Antifreeze (Stop compressor)
25 Phase monitor Water pump **
26 Phase monitor Water pump (Repeated) **
27 Antifreeze (Repeated)
30 High delta Temperatures
31 Wrong trend Temperatures Send / Return
55 Auto Parameterization EVD
57 EPROM default EVD
80 Default values Not updated BLDC
81 High temperature Discahrge BLDC
82 Low delta suctionSuction BLDC
83 Error Start failure BLDC
84 Condition Out of envelope BLDC
CODE DESCRIPTION
100 Error ADC synchronization DRIVE
101 Error Auto tuning DRIVE
102 Overvoltage DC BUS DRIVE
103 Undervoltage DC BUS DRIVE
104 DC ripple Too high DRIVE
105 STO DRIVE
106 Error Output voltage DRIVE
107 Overcurrent DRIVE
108 Overheating DRIVE
109 Overload DRIVE
110 Error Thermistor DRIVE
111 Undertemperature DRIVE
112 Fan DRIVE
113 Error Flash memory DRIVE
114 Error Grounding DRIVE
115 Overcurrent Hardware DRIVE
116 Error Synchronization DRIVE
117 Error Serial communication DRIVE
118 Overload Motor DRIVE
119 Error Motor phases DRIVE
120 Error Default parameters DRIVE
121 Error PFC DRIVE
122 Overvoltage PFC DRIVE
123 Undervoltage PFC DRIVE
124 Error PTC trip DRIVE
125 Error Speed DRIVE
126 Error Detection STO 1 DRIVE
127 Error Detection STO 2 DRIVE
** Alarm occurs only when the phase sequencer is installed