12
Elektropievienojumi (Att. 10 un 10A)
Iekārta (1)
Iekārta VX-400/700 E tiek piegādāta ar apm. 1,0m garu kabeli un kontaktdakšu,
230V, vienfāžu sazemējuma pievienojumu. 10A priekš VX-400 E un 16A priekš VX-
700 E.
Atsevišķs kontrolieris (3)
Systemair VX-400/700 E gaisa apstrādes iekārtas iespējams kontrolēt ar vienu vai
vairākiem CE tipa tālvadības paneļiem.
Taimers (2)
Ja gaisa apstrādes iekārta uzstādīta komerciālā ēkā, ir iespējams pieslēgt
atsevišķu nedēļas taimeri.
Papildus aprīkojums
Sīkākai informācija par difuzoriem, gaisa izmešanas ierīcēm, sienas
restītēm u.c. skatīties tehnisko katalogu un montāžas instrukcijas.
ELECTRICAL CONNECTIONS (Fig. 10 and 10A)
The unit (1)
The VX-400/700 E units are supplied with apx. 1 m cable and plug for, 230V, single
phase earthed connection. 10A for VX-400 E and 16A for VX-700 E.
Seperate controller (3)
The Villavent VX-400/700 E can be controlled from one or more remote control
panels, type CE. For necessary signal, install an unscreened, 4-lead connection
(12V). (Screened cable to be used in areas exposed to EMC noise). Use 4x0,22
or 0,5 mm2 when connected to terminal block, 4x0,14 mm2 if modular plug is
used.
The controller is adaptable in ELKO frame system, and designed for both flush
installation and for installation on the wall by means of a 18 mm double frame..
Timer (2)
If the unit is installed in commercial buildings, separate week timer for automatic
day and night operation (reduced ventilation) may be installed. Cable (2x0,22
mm2 leads) from the timer (fig 10A) to be connected to terminal block in junction
box inside the unit.
When more than one controller is installed, use one or more double inlet plugs
in the plug on the unit. as necessary.
ADDITIONAL EQUIPMENT
For more information about diffusers/louvers, roof unit, wall grill etc., see
technical catalogue and installation instructions.
To Next Page
Loading...
