24 25
en
CLEANING
1. Before cleaning, unlock and remove
the plates, drip trays, and baking tray to
prevent damage to the cooking surface.
Drain the juice drip trays and wash them in
mild soapy water, then dry thoroughly with
a paper towel.
2. Do not immerse the body of grill in water
or any other liquid.
3. The appliance and its cord cannot be
placed in the dishwasher. The heating
elements, visible and accessible parts,
should not be cleaned after removing the
plates. If they are very dirty, wait until the
appliance has completely cooled down
and clean them with a dry cloth.
4. If you do not wish to wash the cooking
plates, drip trays, and baking tray in the
dishwasher, use hot water and a little
washing up liquid to clean, then rinse
thoroughly to remove any residue. Wipe
them carefully with a paper towel.
Do not use metal scouring pads, steel wool
or abrasive cleaners to clean any part of
the grill, use only nylon or non-metallic
cleaning pads.
5. To clean the grill cover, wipe with a warm,
wet sponge and dry with a soft, dry cloth.
6. Always make sure the grill is clean and dry
before storing.
Any repairs must be carried out by an
approved service representative.
5 6
4
1 2
3
Troubleshooting guide
Problem
Cause Solution
Button blinking
+
Indicator light solid blue
+ Button
blinking
• Switching on the
appliance or starting
an automatic cooking
cycle with food
and without plates
preheating (manual
mode is automatically
activated).
• 2 possible options:
– Choose the temperature setting by
pressing the
button and then
press OK. Allow to cook, but you must
monitor the cooking (manual mode).
– stop the appliance, remove the
food, close the appliance properly,
re-program the appliance and wait
until end of preheating.
The appliance stops during the cycle of
pre-heating or cooking.
• The appliance has been
kept open for too long
while cooking.
• The appliance has been
idle too long after the
end of warm up or keep
warm.
• Disconnect the appliance from the
outlet and leave for 2-3 mins., restart
the process. The next time you use the
appliance, make sure you open and
close it quick for best cooking results. If
the problem occurs again contact your
local customer service.
The indicator light will blink purple
+ Button
/ / / blinking
+ Intermittent beeping
• Appliance failure.
• Appliance stored or used
in a room that is too cold.
• Disconnect and reconnect your
appliance and immediately restart a
preheat cycle. If the problem persists,
contact your Customer Service.
The device does not beep.
The indicator light will blink purple
+ Button
blinking
+ Continuous beeping
• Appliance failure. • Unplug the appliance and contact
customer service.
After preheating, I placed the food inside
and closed the appliance,
but the
indicator light stays white and cooking
does not begin.
• The quantity of food
inside the appliance is
greater than 4 cm.
• The quantity of food should not exceed
4 cm.
• The grill was not opened
completely when placing
the food inside.
• Open the grill completely and close it
again.
• The appliance does not
detect food inside The
quantity of food is
insufficient, " OK " is
blinking.
• Confirm cooking activation by pressing
the button
.
The appliance will activate in manual mode
+
The indicator light will blink red.
+ button
temp control and light
fixed
• Preheating time was cut
short.
• Monitor the cooking periodically
(for use in manual mode).
Or
• Stop the grill, remove food, close the grill,
select the new cooking program you wish
to use and wait for the preheating cycle
to finish.
To Next Page
Loading...
