ATW digital weighing scales user’s guide
- 11 -
SECTION 9 CALIBRATION
9.1 Linear calibrate
To start calibration turn the scale off and then turn it back on. Press the limit and
UNIT keys together during the initial counting from 9 to 0 on the display.
The display will show "unLoAd". Remove all weight from the pan and the scale
automatic to set the initial zero point.
The display will then show the first calibration. Put weight on the platform , The
scale should be stable after automatic to accept a weight. The stability indicator will
turn on to show the value is stable.
After all calibrate weight completed, the scale automatic completes the calibration.
The scale will begin counting back to zero after the last weight has been selected.
9.2 Normal calibrate
To start calibration turn the scale off and then turn it back on. Press the Tare and
UNIT keys together during the initial counting from 9 to 0 on the display.
The display will show "unLoAd". Remove all weight from the pan and then the scale
automatic to set the initial zero point. after the stable indication on display shows
“load”, put this weight on platter, after stable indicator on, The scale automatic finish
calibrate.
After self-checking again, AT W is ready for you.
To Next Page
Loading...
Need help?
General
