DHR Series Getting Started Guide Page 30
The Starch Pasting Cell
The Starch Pasting Cell (SPC) is a Smart Swap™ accessory available on all Discovery Series Rheometers.
The option provides a more accurate and powerful tool to characterize the gelatinization of raw and modi-
fied starch products as well as the properties of the starch gels. It can also be used for characterizing many
other highly unstable materials. It uses an innovative impeller design for mixing, reduction of water loss,
and control of sedimentation during testing. The actual sample temperature is measured and controlled in a
temperature chamber with heating/cooling rates up to 30°C/min.
Refer to the Starch Pasting Cell
Getting Started Guide for additional information.
Asphalt Submersion Cell
This temperature control system is specifically for the measurement of asphalt binders immersed in a water
bath. Its operation is covered by the Asphalt Submersion Cell manual.
Refer to the Asphalt Submersion Cell Getting Started Guide
for additional information.
Figure 13 Discovery Series Asphalt Submersion Cell.
To Next Page
Loading...
