TabTimer Careousel MK3/11 - Dispenser Settings

5
Menu A (accessed through Buon 1)
Set CLOCK:
1. Press Buon 1 repeatedly unl ‘CLOCK’ is visible on the display.
2. Set the correct me by using Buons 2 and 3. You can fast forward or reverse the me by
pressing and holding down these buons.
Set DOSES per day:
1. Press Buon 1 repeatedly unl ‘DOSES’ is visible on the display.
2. Wait a few seconds. Adjust to the correct number of doses per day using Buons 2 and 3.
Set ALARM mes:
1. Press Buon 1 repeatedly unl ‘ALARM’ is visible on the display.
2. Set the 1st (1) alarm me using buons 2 and 3.
3. Press Buon 1 again for the 2nd (2) alarm me and repeat the procedure for all
subsequent alarm mes required.
Press and hold down buon 1 for a few seconds to exit the menu and revert to normal
operaon.
DISPENSER SETTINGS
The dispenser is set using 3 buons:
Buon 1 is used for moving to the next funcon.
Buons 2 and 3 are used to change the sengs in each funcon.
There are two seng menus:
MENU A:- Buon 1: DOSES ALARM CLOCK
MENU B:- Buon 3: BEFORE AFTER SOUND LIGHT HOURS DLS
DATE START RECORD TEST
NB: 1. It important that the DATE is set to allow DLS and START funcons to operate.
2. Aer compleon of sengs in either Menu A or B press buon 1 for three seconds
to restore to normal operaon. If nothing is done the display will automacally
return to normal aer 30 seconds.