TabTimer Careousel MK3/11 - Test Function

7
DLS (DAYLIGHT SAVING)
To enable the dispenser to automacally adjust for daylight saving.
Press Buon 1 repeatedly unl ‘DLS’ is displayed.
Using Buons 2 or 3 set at ‘01’ to enable Daylight Saving. Set at ‘00 ‘ to disable.
DATE
Press Buon 1 repeatedly unl ‘DATE’ is displayed. Wait a few seconds. YY will be displayed.
Using buons 2 and 3: Set the Year (YY) then press 1
Using buons 2 and 3: Set the Month (MM) then press 1
Using buons 2 and 3: Set the Date (DD) then press 1
START (START DELAY FUNCTION)
Aer programming the doses and alarm mes it is possible to delay the me at which the
dispenser will start to operate. This funcon is useful if the dispenser is being lled osite, for
example, by a pharmacy and not being delivered to the user unl a later date.
Press Buon 1 repeatedly unl ‘START’ is displayed.
Wait a few seconds. YY will displayed.
Using buons 2 and 3: Set the Year (YY) then press 1
Using buons 2 and 3: Set the Month (MM) then press 1
Using buons 2 and 3: Set the Date (DD) then press 1
Using buons 2 and 3: Set the Hour (HH) then press 1.
The me (HH) should be in advance of the rst dose to be dispensed for the user.
If this funcon is not required do not set.
Note: If at any me you go back to check the START seng at a later me the display will show
the pre-set DATE sengs. The START seng will not be displayed and it should be re-set.
RECORD
The dispenser will record the actual mes the previous 28 medicines were dispensed.
Press Buon 1 repeatedly unl ‘RECORD’ is displayed. The me that the last medicine was
taken is displayed. Press Buons 2 or 3 for all of the mes medicine was dispensed over the
previous medicine cycle to be shown.
TEST FUNCTION
The dispenser has an inbuilt test funcon. To test the rotaon and alarm sounds:
Press Buon 1 repeatedly unl ‘TEST’ is displayed.
Press Buon 3 – the tray will rotate, ‘MOVING’ and then ‘TAKE’ is displayed.
The alarm will sound. Tilt the dispenser to stop the alarm. ‘TEST’ is then displayed again.
To test the ‘BEFORE’ funcon, Press Buon 1 unl ‘TEST’ is displayed. Press Buon 2.
Close the lid and then turn the dispenser upside down twice. Turn back to the upright
posion. The tray will rotate and the alarm will sound. Tilt the dispenser again to cancel.
Hold Buon 1 down to return to clock.