TACKLIFE PMS01X - Additional Safety Instructions

Additional Safety Instructions For Your Mitre Saw
Remove the plug from the socket before carrying out any adjustment, servicing or maintenance.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18
19.
20.
21.
Only wood or products such as medium density fibre board can be cut with this saw. Other materials
may shatter or cause the blade to grab.
Never fit substandard blades. Only fit correctly sized saw blades.
Let the blade reach full speed before commencing the cut.
Do not use damaged or worn blades.
Ensure that the direction arrow marked on the blade corresponds with the rotational direction of motor.
Ensure the movable guard operates freely with out any jamming.
Never cut pieces too small to be held securely against the straight guide. Leave enough space for the
hand to be a safe distance from the blade.
Regularly check the blade-securing bolt.
Do not run the machine with any part of the casing missing or damaged.
Do not start the saw when the blade is inserted into the work-piece.
Before cutting let the saw blade run freely for a few seconds. If it makes an unfamiliar sound or vibration
switch it off immediately and disconnect from the power supply.
Never try to cut freehand. Always ensure that the work-piece is securely pressed against the straight
guide and blade support surface.
Do not forget to remove any adjustment keys, spanner and wrenches before switching on the tool.
When the machine is operating, keep hands away from the cutting area.
Always ensure the safety guard is in working order before use. Should the guard not close quickly over
the saw blade, do not use.
Do not tie or wedge open the safety guard.
Only use blades with the correct bore size for the spindle.
Do not cut into screws or nails. Inspect workpiece for nails and screws before use.
Keep the power cord well away from the cutting area during use. Always position the cord so that it will
not be caught in the work-piece when the saw is in use.
Do not use the saw to cut other than aluminium, wood or similar materials.
Take care when slotting.
04