(844) 482-2822
POWERING ON AND RECORDING
GETTING TO KNOW YOUR TACTACAM:
1. Push the Rec/Power button. You will
feel the camera vibrate 2 times and see a
blinking green light coming from the
Rec/Power button. The green LED must
be blinking for the camera to be recording.
The process takes approximately 3 seconds.
Note: If light does not begin to ash, make
sure your SD Card is installed, formatted,
and not lled with videos
2. To pause your recording quickly push
the Rec/Power button. The camera will
vibrate 1 time and the green light will go
solid.
3. While paused, push and hold the
power button for 3 seconds to turn on the
Wi-Fi Push and hold the power button for 3
seconds when the Wi-Fi is ON to turn off the
Wi-Fi.
4. To power your camera completely off,
just push and hold for 5 seconds to power
camera off.
5. The camera will automatically power
off to save battery when not recording
(left in pause mode) after 3 minutes.
To Next Page
Loading...
Need help?
General
