16
1. Make sure that the SD card is not full. If the SD card is full, the camera
will stop taking images. Users can turn on SD Loop to avoid such
problems. This will cause the SD card to overwrite older images.
2. Make sure that alkaline or NiMH-AA batteries have enough power for the
camera to work.
3. Format the SD card with the camera before using or when the camera
stops taking images.
CAMERA STOPS TAKING IMAGES OR WON’T TAKE IMAGES
TROUBLESHOOTING
The Reveal is IP66 rated waterproof. This means the camera is water
resistant against powerful jets. The only way the Reveal can get
condensation in or behind the lens is if the antenna is not screwed in
all the way, or if there is dirt or debris on the seal. Follow these at home
instructions to alleviate this issue if need be:
• Pull the SD card out and let the camera sit for 3-4 days open, in an area where
there is circulating air (fan or vent).
• You can also put in a sealed container with rice for 24 hours to draw out the
moisture.
• Clean the seal well and tighten your antenna.
• Place back out in the eld.
1. Do not open the camera right away.
2. Be sure to dry the outer housing of the camera, preventing water from
entering the inside of the camera and causing internal damage.
INTERNAL CONDENSATION ON LENS
IF THE CAMERA HAS ACCIDENTALLY BEEN SUBMERGED IN WATER
To Next Page
Loading...
Need help?
General
