TM9100 Installation Guide Preface 5
© Tait Electronics Limited August 2005
Preface
Scope of Manual
This manual describes the installation of the TM9100 mobile radio using the
U-bracket, and how to install and connect the microphone, antenna,
emergency switch, and external alert device.
Other cradle mounting arrangements are available for the TM9100 radio,
but are not described in this manual.
The installation of accessories and mounting options is described in the
installation instructions provided with the equipment, and the relevant
section in the service manual.
Enquiries and Comments
If you have any enquiries regarding this manual, or any comments,
suggestions or notifications of errors, please contact Technical Support, Tait
Electronics Ltd, Christchurch, New Zealand (refer to “Contact
information” on page 2).
Updates of Manual and Equipment
In the interests of improving the performance, reliability, or servicing of the
equipment, Tait Electronics Ltd reserves the right to update the equipment
or this manual or both without prior notice.
Copyright
All information contained in this manual is the property of Tait Electronics
Ltd. All rights are reserved. This manual may not, in whole or in part, be
copied, photocopied, reproduced, translated, stored, or reduced to any
electronic medium or machine-readable form, without prior written
permission from Tait Electronics Limited. All trade names referenced are the
service mark, trademark or registered trademark of the
respective manufacturers.
To Next Page
Loading...
