Tait TP9400 Battery Charging Guide

10 Battery Charging Guide
English
Charging a battery for the first time
Fully charge a battery before using it for the first time.
The red LED stays lit while the battery charges.
Charging a battery
Notice For best charging performance, switch off the radio before
placing it in the charger (not for battery-only vehicle charger).
1 Desktop charger: Connect the charger to the correct Tait power
adaptor.
6-way charger and vehicle charger: Power on the charger.
Initially, all three LEDs are lit for 2 seconds.
2 Place just a battery in the charger, or a radio with a battery
attached (desktop charger or 6-way charger only). There is no
need to remove a belt clip, antenna, or any accessory that is
attached to the accessory connector.
The red LED lights up, and stays lit while the battery charges.
When charging is complete, the green LED stays lit.

Tait TP9400 Specifications

General

Battery Type	Li-Ion
Digital Protocol	DMR Tier II
Channel Spacing	12.5 kHz, 25 kHz
Operating Temperature	-30°C to +60°C (-22°F to +140°F)
Operating Voltage	7.4 V
Channels	1000