Tait TP9400 Battery Charging Guide

8 Battery Charging Guide
English
■ If no charger LED stays lit, the charger will resume charging only
when the ignition is switched on again. Minimal charger standby
power will be drawn from the vehicle battery until then.
■ If a charger LED stays lit, the charger will continue to charge the
radio battery even while the ignition is off, and will continue to
draw power from the vehicle battery. Once the battery is charged,
the charger draws minimal current and has little effect on a
healthy vehicle battery.
Receiving calls while charging (not for battery-only
vehicle charger)
Notice For best charging performance, switch off the radio before
placing it in the charger.
You can receive a call while the radio is in the charger, but your radio
performance may be degraded. If you do remove the radio from the
charger to answer a call, the call will not be disrupted.
Removing the radio from the charger to make or receive a call ends
the charging process. Charging safely recommences when the radio is
reinserted into the charger.
If a radio was turned on while being charged, the battery indicator may
not be accurate when the radio is initially removed from the charger.
After a few seconds, the battery indicator is updated to display the
amount of charge available in the battery
.

Tait TP9400 Specifications

General

Battery Type	Li-Ion
Digital Protocol	DMR Tier II
Channel Spacing	12.5 kHz, 25 kHz
Operating Temperature	-30°C to +60°C (-22°F to +140°F)
Operating Voltage	7.4 V
Channels	1000