What to do if the fixed position signal is not detected on my TAJIMA Sewing Machine?
If the fixed position signal (main shaft Z signal) is not detected, return the main shaft to the fixed position and check the encoder signal on your TAJIMA Sewing Machine.
Details critical safety instructions with warning symbols and signal words for secure operation.
Guidelines for installing the machine in a suitable environment for optimal performance and safety.
Essential precautions to be taken during machine operation to ensure safety and prevent damage.
Illustrates the locations where warning labels are applied on the machine.
Explains the operation of the main power switch and the emergency stop button.
Details how to start and stop the machine using different switch types.
Step-by-step guide for the basic operation sequence of the machine.
Instructions for inputting design data directly into the machine's memory.
Lists error codes, stop factors, and corrective actions when the machine stops.
Addresses common symptoms, their causes, and necessary adjustments or repairs.
General maintenance procedures including cleaning, lubrication, and greasing.
General| Type | Embroidery Machine |
|---|---|
| Thread Break Detection | Yes |
| USB Port | Yes |
| Weight | Varies by model |
| Number of Needles | 6, 9, 12 |
| Maximum Embroidery Area | 500 x 360 mm |
| Maximum Speed | 1200 RPM |
| Needle Count | 6, 9, 12 |
| Display | LCD Touch Screen |
| Power Requirements | 220V, 50/60Hz |
| Stitches per Minute | 1200 SPM |
| Model | TEHX-C Series |
To Next Page
