What to do when the machine stopped
224
Chapter 9
TP09
32A
The machine cannot memorize excitation of X-axis
driver.
Turn "OFF/ON" the power.
Check connection of each frame driver motor and/
or sensor wire.
Replace the corresponding frame driver or frame
motor.
32B
The machine cannot memorize excitation of Y-axis
driver.
32C Incompletion of X-axis frame travel Turn "OFF/ON" the power, or switch from sleep
mode to normal mode. (Each driver setting will be
reset.) When it is not possible to recover from the
trouble, replace the card.
32D Incompletion of Y-axis frame travel
32E
The machine cannot complete X-axis origin search
within the time.
Check setting for embroidery space at software
installation. Check the sensor card.
32F
The machine cannot complete Y-axis origin search
within the time.
354
Sequin motor, color change motor, ATH motor
overcurrent
Turn OFF/ON the power. Check and/or replace the
head card. Decrease R.P.M.
362 Jump motor overcurrent
376 Presser foot position error(TMBR-SC)
Turn "OFF/ON" the power. Check or replace the
control card.
378 Presser foot driver error(TMBR-SC)
382
The needle position signal status during color
change does not change for 1 second and more.
Check the power supply circuit for the color change
motor.
Check the potentiometer (needle position sensor).
383
Needle position was abnormal.
Check setting for the number of needles at
installation of software.
There was no needle position signal during rotation
of the main shaft.
Check the potentiometer (needle position sensor).
387 Color change motor sensor error Check encoder signal wire of color change motor.
3A6
ATH movable knife retractable position has become
nonuniform.
Check the position of ATH movable knife.
3A9 Upper thread holding motor overcurrent
Turn OFF/ON the power. Check and/or replace
head card.
3B5
Communication error (between CPU card USB
hub), power supply system error of 280 V or 24 V,
abnormality of power supply card
Check harness connection between CPU card and
USB hub.
Check and/or replace power supply card.
Check and/or replace DC power supply.
Wrong selection of model at installation of software Install the software again.
3B7
Communication error inside the controller, bad
communication (between CPU card and switch
card)
Turn "OFF/ON" the power.
Check harness connection between CPU card and
switch card.
Replace CPU card or switch card.
3BF Remaining number of beads cannot be grasped. Check and/or replace the head card.
No. Stop factor How to restore
To Next Page
Loading...
