Registration of a design into the machine memory
38
Chapter 4
SQ06
(4) To read condition data (file)
If the saving format of the selected design is T3 or T2, the following message will appear.
Condition file means Color Change Sequence and Design Start Position.
(5) To move frame to the design start position
After that, proceed to "To decide color change sequence (Needle Bar Selection) (p.50)".
When performing this operation, do not put your hands, etc. on the table. Moving the
frame could injure you.
Pressing SET will move the frame, then data set will be
completed.
When the movement of the frame is not desired
Data set is completed.
OK to move a
frame to the Start
Point of Design
Data?
To Next Page
Loading...
