Attachment Installation
Installing the Battery:
Align the battery with the two small slots at the bottom of the
walkie-talkie case. Press the battery towards the aluminum plate until
you hear a "click" from the small sliders on both sides at the top,
indicating the battery is installed.
Removing the Battery:
There are two small sliders with arrow symbols on the top sides of the
battery. Press them down simultaneously to remove the battery.
Installing the Belt Clip:
Remove the battery, then press the belt clip downwards into the
smooth slot on the back of the battery until it clicks into place.
Removing the Belt Clip:
Remove the battery, press the elastic plastic piece in the middle of the
belt clip towards the walkie-talkie, and pull the belt clip upwards to
detach it.
Installing the Antenna:
Hold the base of the antenna and screw it clockwise into the antenna
socket at the top of the walkie-talkie until it is tight.
To Next Page
Loading...