1
Waking up the system
To make a call you need to wake up the system from standby
Pick up the remote control
To wake up the system just pick
up the remote control or press
any key. You may have to point
the remote control towards the
system to make it discover you.
The system will now show the
welcome screen.
Incoming calls will wake up the system!
The system is in standby mode whenever it is not used (but still plugged in). The
screen is black in standby. Any incoming call will wake up the system from
standby.
There are some restrictions to this if the Do Not Disturb function has been
activated.
If the system fails to respond
Should the system fail to respond, make sure that:
The system is connected to electricity
The remote control has working batteries
To Next Page
Loading...
