Tandy Color Computer 3 - Page 21

Installation
If
your
video display unit is an
RGB monitor,
such
as
Tandy's
CM-8
Analog
Monitor
(26-3215),
follow these
steps:
1.
Turn your Color Computer
3
over so
the
bottom
panel is
exposed. Locate
the RGB OUT connector.
2. The
RGB monitor
has
a
computer cable
wired into
the back
of
it.
Plug this
cable into the RGB OUT
connector
on
the bottom
of
the computer.
3. Guide
the
cable through
the
channel
so it
is
out of
the
way. (See
Figure
8.)
Figure 8. RGB
monitor
connection.
11