8
DAB Mode
Switching ON/OFF
1. Connect the power adapter between your radio and the mains socket, your radio will
be in standby mode.
2. Extract the telescopic antenna, and then press /VOLUME knob to switch unit on.
Press /VOLUME knob again to switch it to standby mode.
3. For initial use, the unit will automatically enter DAB mode and carry out a full scan.
During scan the display will show a slide bar that indicates the progress of the scan
and the amount of stations that have been found so far.
4. Once the scanning is finished, the DAB stations will be displayed in alphanumeric
order and the first station in the list will be broadcasted.
Selecting another station
1. Turn TUNE/SELECT knob to browse station list and then press TUNE/SELECT knob
to confirm your selection.
2. Or, you can press MENU button to find 'Station list', then turn TUNE/SELECT knob
to browse and press to confirm.
Auto scan
If no DAB signal is found in your area, you may need to relocate your radio and perform an
auto scan.
To activate auto scan, press MENU button and then turn TUNE/SELECT knob to select
'Full scan', press TUNE/SELECT knob to confirm. You can also press SCAN button on the
unit to scan automatically.
To Next Page
Loading...
Need help?
General
