Troubleshooting
There is no power
• Power adaptor is not connected correctly.
• No power at the power outlet.
• Use the wrong adapter instead of the original one included.
• Power knob is not turned on, turn the Power/Volume knob clockwise to turn on.
Turntable v
olume is
too low, turn
it clockwise to volume up. Audio source volume is set too low.
Stylus protector is still on.
Tone arm is lifted up but not on the record. Lower it down using the tonearm lift.
Volume is not loud enough or not good: connect to the external powered speakers.
Power is on, but the platter does not turn
• Turntable drive belt has slipped off.
• An aux in cable is plugged into the aux in jack, unplug it.
• Bluetooth is connected, disconnect it and reset the mode to "PHO"
Turntable is spinning, but no sound, or not loud enough
USB Recording not working
USB is not being formatted in FAT/FAT32 format.
USB flash drive has little room for storage.
USB is pulled out when recording is working.
User didn't press and hold "M" button till enter into recording mode.
My record is skipping.
• Use the tonearm lift raise up and down the arm for 10 times before initial spinning.
• Change vinyl records or clean the vinyl records grooves properly even it's new record.
• The needle is not in the middle of the stylus or broken, replace it using above method.
• Put the record player on the flat surface with 4 legs/corners on the ground.
• The white stylus protector is till on.
To Next Page
Loading...