TaoTronics TT-AH018 - Cleaning and Maintenance

Caution: Unplug the power source and wait for 3 minutes to allow the unit to
cool down before you turn it on again.
05/06
High Temperature Alarm
High temperature alarm will be activated if temperature of the heat tube is too high, 8
beep sounds will be heard every other second. The unit will stop working after 1
minute.
Cleaning and Maintenance
Make sure to turn off the unit and unplug it from the power source before cleaning.
1. Remove the tank from the base and drain water.
2. Fill the tank half full and add 100ml 5% white vinegar. Run the humidier for 5-10
minutes to allow the mixture to work through and loosen up the gunk.
3. Use the included cleaning brush for better cleaning.
4. Be careful when you drain water to avoid water getting into the underside or motor
area and damage the product.
5. Use a soft cloth to wipe the outside of the unit to remove any ngerprints, smudges,
etc.. The cloth can be damped with water, or dipped with a bit of gentle cleaner or
vinegar / water solution.
6. Clean the humidier once a week.
Removing the Floater
2. Match the large
notch on the other side
3. Push in the large plug
to secure in place
1. Pull out the small
plug f irst
1. Align and insert the
small notch
2. Withdraw the large notch to
remove the oater
Installing the Floater