1. Tank Cover
2. Nozzles
3. LED Display
4. Power Cable
5. Power Button
6. Sleep Button
7. Humidity Button
8. Mist Button
9. Timer Button
10. Warm Mist Button
11. Tank Handle
12. Water Tank
13. Mist Tube
14. Atomizer
15. Air Outlet
16. Floater
OPERATIONS AND FUNCTIONS
1 2
3 4
Add Water
1-2. Remove the tank cover, take out the water tank by holding the tank handle.
3. Fill the tank with clean water.
4-5. Place the tank back into the base, cap on the cover. Please make sure it fits together securely so
that water can go from the tank to the reservoir.
6. Connect to an appropriate power source. The unit enters standby mode with a beep sound, the
LED display shows the relative humidity of current environment.
5
1
2
3
4
1. If tap water is too hard, it is recommended to use filtered or distilled water to avoid white
dust. DO NOT use hot water.
2. DO NOT add any essential oils or medicinal tablets into the water tank.
3. DO NOT add water into the base or through nozzle.
4. DO NOT move the humidifier while the water tank is full of water to avoid leakage or base
overfilling.
5. You can fill the water tank without removing it from the base, pay attention to avoid water
getting into the air outlet.
PRODUCT DIAGRAM
08
07
1
2
3
4
5
6
7
8
9
10
11
12
13
14
16
15
5
To Next Page
Loading...
Need help?
General
