1. Turn off and unplug the humidier. Remove the nozzle.
2. Remove the water tank from the base. Remove the tank cap. Make sure that the white
sealing ring does not come off. Drain water from the water tank and base. Remove any
accessories and set them aside.
3. Fill the water tank half full. Add 1 teaspoon of undiluted distilled white vinegar. Attach the
tank cap and shake the tank for 15 seconds.
4. Place the tank onto the base. The vinegar solution will enter the water reservoir to loosen
mineral buildup (scale) on the atomizer, water oater and the bottom of the water tank.
Set it still for 15-20 minutes.
5. Uncap the tank cap and drain the solution. Wipe the atomizer and oater with a soft cloth
to remove loosened mineral deposits.
6. Rinse both the water reservoir and water tank until the smell of vinegar (for scale removal)
or bleach solution (for disinfecting, see below) is gone.
Disinfecting Instructions
1. Follow steps 1-2 of the previous section on scale removal.
2. Fill the water tank half full. Add ½ tsp of bleach. Place the tank cap back on. Swish the
solution around in tank. Place the tank on the base. The bleach solution will enter and
disinfect the water reservoir as well as the other components. Set it still for 15-20 minutes.
3. Follow steps 4-6 of the previous section on scale removal to complete disinfecting the
humidier.
1. Follow the cleaning instructions when the humidier will not be used for at least one week,
or at the end of the season. Remove any accessories used with the humidier and allow the
humidier and accessories to dry completely before storing.
2. DO NOT store with water inside the base, water reservoir, or tank.
3. Pack the unit safely and store in a cool, dry location.
Clean the Dustproof Sponge
Clean the dustproof sponge (at the back of base) with water or detergent once a month. Put
it back in place after cleaning.
push
End-Of-Season Care and Storage
11
12
push
To Next Page
Loading...
Need help?
General
