Standby Mode
Insert the power adapter into the humidifier, and then connect it to
a power source. The unit is in Standby mode now.
Power On / Off
• Rotate the control knob clockwise to the position. The power
indicator will light up white, indicating the humidifier has been
turned on to a minimum mist level.
• If there is no operation for 40 seconds, the power indicator will
turn off. Rotate the control knob slightly to turn the indicator on
again.
• Rotate the control knob counterclockwise to the position to
turn off the humidifier (mist off & indicator off).
Mist Level Adjustment
• Rotate the control knob clockwise ( -> ) to increase the mist
level.
• Rotate the control knob counterclockwise ( -> ) to decrease
the mist level.
Low Water Protection / Water Tank Off Place
• When there is not enough water inside the water reservoir or the
water tank is lifted up, the humidifier will stop misting and the
indicator will flash red.
• Fill the tank with filtered or purified cold water, and place the tank
back onto the base with the triangle marks (▽ & △) aligned. The
red indicator will turn white and the unit will start misting again if
power is not disconnected.
12
11
1 2 3 4
1. If tap water is too hard, it is recommended to use filtered or distilled water to avoid white
dust. DO NOT use hot water.
2. DO NOT add any essential oils or medicinal tablets into the water tank.
3. DO NOT move the humidifier while the water tank is full of water to avoid leakage or base
overfilling.
4. You can fill the water tank without removing it from the base, pay attention to avoid water
getting into the air outlet.
Control Knob
To Next Page
Loading...
Need help?
General
