Tapeswitch PRSU/4 - User Manual

© Copyright (2021) All rights reserved. Changes, which serve technical improvements are reserved.
1
PRSU Series, Operating Instructions Manual (Revision 1.0)
TAPESWITCH CORP.
100 Schmitt Boulevard
Farmingdale
New York 11735
Phone: 800-234-8273
Fax: 631-630-0454
info@tapeswitch.com
www.tapeswitch.com
Introduction
This operating instruction shall familiarize you with the safety relay controller
models: PRSU/2, PRSU/4 and PRSU/5.
Target Audience
These operating instructions are addressed to the following personnel:
▪ Skilled personnel who plan or develop safety equipment for machines
and plants, who are familiar with the safety instructions and safety
regulations.
▪ Skilled personnel who build, install, maintain and operate safety
equipment in plants and machinery.
Symbol Key
These operating instructions contain several symbols which are used to
highlight important information:
This symbol indicates text passages which must absolutely be paid attention
to. Disregarding may lead to serious personal injury or damage to property.
This symbol indicates text passages which contain important information.
This sign is used to indicate actions by the installer or operator.
This sign illustrates that a condition has changed after an action has been
carried out.
PRSU/2, PRSU/4, PRSU/5
Operating Instructions Manual
Safety controllers for safety mats and
sensing edge products

Tapeswitch PRSU/4 Specifications

General

Brand	Tapeswitch
Model	PRSU/4
Category	Controller
Language	English

Summary

Introduction and Target Audience

Introduction

Provides an overview of the operating instructions for the safety relay controller.

Target Audience

Identifies the skilled personnel for whom these operating instructions are intended.

Symbol Key

Explains symbols used within the document to highlight important information.

Safety Information

Safety Indications

Details the intended application and safety principles for the PRSU safety relays.

Safety Warning

Lists critical safety warnings and precautions for device operation and maintenance.

Product Electrical Overviews

PRSU;2 Electrical Overview

Presents the functional schematic and terminal layout for the PRSU/2 model.

PRSU;4 Electrical Overview

Details the functional schematic and terminal layout for the PRSU/4 model.

PRSU;5 Electrical Overview

Outlines the functional schematic and terminal layout for the PRSU/5 model.

Device Installation and Configuration

Device Startup Verification

Provides steps to verify correct operation of PRSU units after installation.

Recommended Limits

Specifies application limits and guidelines for safety products.

Common Device Configurations

Illustrates common wiring configurations for the safety relays.

Device Mounting and Unmounting

Describes procedures for mounting and unmounting the safety relay units.

Electrical Connections

Details wiring configurations for different operational modes.

Maintenance and Troubleshooting

Maintenance Info and Replacement Procedure

Outlines the procedure for replacing a defective safety relay unit.

Fault Diagnostic and Subsequent Measures

Provides a guide for diagnosing faults and taking corrective actions.

Technical Data

Technical Data (PRSU;2)

Lists detailed electrical, mechanical, and environmental specifications for the PRSU/2 model.

Technical Data (PRSU;4, PRSU;5)

Provides technical specifications for the PRSU/4 and PRSU/5 models.