Tapo RV10 Plus - Clean the Main Brush; Clean the Side Brush

Clean the Main Brush Clean the Side Brush
1. Turn the robot vacuum
over, then unlatch and
remove the main
brush cover.
3. Remove any hair or
debris with the
cleaning brush.
4. Re-install the cap and
main brush. Press on
the main brush cover to
lock it in place.
2. Re-install the side brush and press it tightly to ensure it is
installed in place.
1. Pull rmly to remove the side brush and remove any entangled
debris. Wipe with a damp cloth if needed.
2. Remove the brush and
its end cap.
12