10
If there are yellow or red led indications during this test, another location for the receiver
is required. Sometimes moving the receiver 10 cm’s to another location could make all
the difference.
TESTING THE BLU EYE ANTENNA LOCATION:
Connect the antenna to the Blu Eye receiver.
Start the engine and let it run idle for approximately 60 – 120 seconds.
If no yellow or red leds come on during this test and the antenna and cable are in
their final position*, the chosen location for the antenna is good. Continue with:
'Registration of your Target Blu Eye'
If there are yellow or red led indications during this test, another location for the
antenna is required. Sometimes moving the antenna a few centimeters could make
all the difference.
Interference may be caused when the antenna cable is routed against or very close to
the vehicle‘s wiring looms. In some cases the interference can be eliminated by moving
the antenna cable a short distance away from the vehicle’s loom.
If the above was successfully solved, continue with: 'Registration of your Target
Blu Eye'
To Next Page
Loading...