3 – Preparation
Panel lock function
When in shift mode (when the SHIFT indicator is lit),
press and hold the DISPLAY [LOCK] button to turn the
panel lock function on or off. You can also turn it on/off by
pressing the DISPLAY [LOCK] button while pressing and
holding the SHIFT button.
When it is on, all the buttons on the front panel of the unit
(except the SHIFT and DISPLAY [LOCK] buttons) and the
remote control are disabled.
LOCKED
will appear on the
display if you push any of the buttons.
NOTE
Even when the panel lock function is enabled, the
•
unit can be controlled by a TASCAM RC-3F footswitch
connected to the REMOTE jack on the front panel and
external controllers connected to the RS-232C connector
and CONTROL I/O PARALLEL connectors on the rear
panel.
The panel lock setting (on/off) is saved even if the unit
•
power is turned off.
To Next Page
Loading...
