Taski swingo 350E - Beginning Work with the Machine

63
Dosing examples:
Dosing variants
Pre-cleaning
Beginning work with the machine
Manual program start
Notice:
For a precise dosage, use the scale in the
dosage cup.
The filling level mark on the tank corre-
sponds to the mark in the dosage cup. The
type of machine is noted in the dosage
cup!
Information on the packing of
the product
Tank capaci-
ty
Product vol-
ume per tank
filling
0.25% 25 ml for 10l
of water
10l 0.25l
0.5% 50ml for 10l
of water
10l 0.5l
• Fill the dosing cup with a suitable product and pour the con-
tent into the fresh water tank. Repeat the procedure until
the required dosing is reached.
• When dosing is finished, the dosing cup will remain in the
tank.
• The TASKI J-Flex or the QFM dosing station can also be
used for simple and fast dosing.
For further details, please contact your TASKI service part-
ner.
Attention:
Remove any objects (wooden, metal parts
etc.) from the cleaning surface.
The objects could be catapulted by the ro -
tating tool, and thereby cause injuries to
people and damage to the environment.
Attention:
Always wear slip-resistant shoes and ap-
propriate working clothes when working
with this machine!
Attention:
Start familiarization with the machine by
making your first driving attempts in a free
area.
• Bring the machine into operating po-
sition by swinging up the parking
support.
When lifting the machine, the parking
support is folded up by a spring.
• Operate the adjusting lever at the
machine handle and lower the guide
bar slowly until your arms are
stretched out (working position).
• Release the adjusting lever to lock the guide bar.
• Switch on the machine (main switch).
Switch lights up
• Switch off the suction unit.
Switch lights up
• Press the switch cleaning solution.
Switch lights up
• Use the quantity control to dose the
cleaning solution.
• Press the operating lever.
The tool is activated.
EN