Tattile ANPR MOBILE Series - Preparation and Installation; Building the Connector Cables

 4PreparationandInstallation
RMM_00029_09 21 / 42 ANPR Mobile
4 Preparation and Installation
4.1 Package Content
Thefollowingproductsareincludedinthepackage:
 ANPRMOBILEDevice.
 Matingpartskit,cod:T17493


FormoreinformationonthepurchaseddevicemodelrefertotheTechnicalSpecifications .


4.2 Building the Connector Cables
Goodequipmentoperationisguaranteedonlybyrespectingtheinstructionscontainedinthismanual.
Tattiledeclinesallresponsibilityforanomalousequipmentbehavior,iftheinstallationdoesnotfollow
theseinstructions:
‐Alwaysobservethepolaritiesofthepowersuppliesandthepowerrequirementsspecifiedinmanual.
‐Mountthedeviceona
mechanicallystablestructure,wellconnectedtoelectricalground.
‐Removethepowersupplyvoltagefromthedevicebeforeunpluggingthepowerconnector.
‐Turnoffallelectricalpowerbeforemakingorbreakinganyelectricalconnections.Makingorbreaking
connectionswhenpowerisoncanresultindamagetothedevice.
‐
ElectromagneticInterferences(EMI)andElectrostaticDischarges(ESD)cancauseproblemswhityour
device.
‐Donotsharethemainpowersupply(VMAIN)withotherequipment.Useadedicatedpowersupply.
‐Donotplacethepowersupplyandsignalcablesparalleltocablescarryinghigh‐currentswitching
voltages.
‐The
powersupplycablemustbeshielded.
 

