Tattile ANPR MOBILE Series - Mounting the Product; Device check

 4PreparationandInstallation
RMM_00029_09 23 / 42 ANPR Mobile
4.3 Mounting the Product

NOTICE!Electromagneticinterference(EMI)andElectrostaticdischarge(ESD)
AninstallationenvironmentwithEMIandESDcanaffectthequalityofthedatatransmittedbythe
camera,orevencausetheinterruptionofdatatransfer.
 Donotpositioncablesparalleltowirescarryinghigh‐current,switchingvoltages(e.g.,electrical
devicesthatemployswitchingtechnology).
 Installthedeviceandcablesasfaraspossiblefromdevicesgeneratingsparks.


Makesure:
 Thedeviceiscorrectlycabled.
 TheIPaddressofthedeviceisavailable.
 APCforremoteconnectionisavailable.






4.3.1 Device check

Makesurethecameracomplieswiththefocusdistancedefinedduringtheprojectconfiguration.
Formoreinformation:
 Logintothewebinterface.
 OpentheDeviceInformationsection.
 CheckthevaluesspecifiedfortheChannelnbestfocusparameter.

2. CablethedeviceandconnectthedevicetoaPC.
3. Startupthedevice.
Afterabout60secondstheoperatingsystemisreadyforuse.
4. SearchforthedeviceusingthespecificcommandoftheTattilePathfinder.
5. Openthelivestreamofthedevicetocheckfor
thecorrectframing.
6. Ifneeded adjustthedeviceorientationmovingthewall‐mountbracket.
 Thedeviceisreadyforuse.