Remote Control
'"
Installing
battery
Remove the battery cover, and insert two AAA (1.5V) batteries; make sure that the polarity
of
the battery is
consistent with the marks
"+/-"
in
the battery slot.
Precautions
of
remote
control
usage
• Point the remote control to the receiver window. The objects between remote control and the receiver
window may disturb the
normal operation.
• Keep the remote control away from strong vibration.
In
addition, do not set
or
put the remote control
in
direct sunshine, which may result
in
deformation
of
the remote control.
•
The remote control may
be
invalid
if
the receiver window is
in
direct sunshine or strong light;
in
this case,
please adjust the angle
of
the light
or
the device,
or
approach the remote control to the receiver window.
• The
eff
,ective range
of
the remote control may be affected
if
the battery voltage is low;
in
this case, please
replace
with a new battery;
if
the remote control won't be used or battery voltage is too low, please take out
the battery to avoid corrosion due to battery
liquid leakage.
•
Do
not mix different types
of
batteries,
or
used and new batteries.
•
Do
not throw the batteries into fire, charge
or
break up,
or
charge, short circuit, disassemble, heat
or
bum
the used batteries.
Please follow the environmental protection regulations to disposal
of
the batteries.
Basic Operations
Turning on/Standby
Insert the power plug into the outlet.
Press"
0"
button
on
the Monitor set(lf it doesn't have this button, you needn't
operate this step), and
press"
l!J"
key
on
the remote control or
on
the control panel
to
tum
on
the Monitor set. When
the Monitor set is working, press
"l!J"
key
to
switch the Monitor set to standby state.
* Special note
This device adopts energy saving technology:
1.
If there
is
no signal input
in
power
on
state, the Monitor set enters standby state automatically after five minutes.
2.
When the schedule power off time
is
reached, the Monitor set enters standby state automatically.
Signal source selection
Press "SOURCE" key either
on
the remote control or
on
the control panel. The menu
of
"Input Source" will
be
displayed
on
the screen. Then press
"J;,J~"
key
on
remote control
or "CH+/CH-" key
on
the control panel
to
choose the signal source. Press "OK" key
on
the
remote
control or "MENU" key
on
the control panel and Monitor will switch the current signal
source
to
the signal source you choose.
Menu operation description
Press "MENU" key
on
the remote control or
on
the control panel,
then the Monitorwill display the main menu.
1.
Press
"~/~"
key
on
the remote control or "VOL+NOL-" key
on
the control panel
to
select the adjustment sort menu, which
includes 4 sorts:
PICTURE, SOUND, OSD, Monitor.
2.
Press
"~"
key
on
the remote control or
"CH_"
key
on
the control
panel
to
enter the adjustment sort menu.
3.
Press
"Ji./~"
key
on
the remote control or "CH+/CH-" key
on
the
control panel
to
select what is needed
to
adjust
in
sort menu.
7
r----------,
To Next Page
Loading...
Need help?
General
