UltraForce
10
2.2 Faults and Troubleshooting
The equipment runs through regular quality controls during production. Nevertheless, errors
or malfunctions on the equipment may occur. Individual parts are often the cause of faults
and replacement is usually sucient. Please use the following overview to see the ve most
common errors and how to repair them. If the equipment still does not work properly, please
contact your contract partner.
Error Cause Repair
Scraping noises
Cable or wheels are not
running smoothly or are
damaged
Visual inspection of the cable run or
the wheel guide
No resistance Defective cylinder Check the cylinder for resistance
Squeaking &
cracking noises
Loose or too tight screw
connection
Check or lubricate screw connection
2.3 Maintenance and service calendar
The multi-gym needs to be cleaned after every training session with a moist towel (no solvent!)
in order to avoid damage caused by sweat.
The following routine work must be done in the specied time intervals:
Part Weekly Monthly 2x annually Annually
Pulling ropes and rollers C / I
Bolts
I
Wheels and rope guide
I
Legends: C = cleaning; I = inspect
To Next Page
Loading...
Need help?
General
