UltraForce
16
3.3 Assembly
In a few cases, our products contain parts that were pre-lubricated in the factory. During
assembly and during training, we recommend protecting your oor with the mat.
Make sure that you have completely read the instructions and all parts and tools on p. 17
are available.
Approximately an 83 degree tilted angle is required to transport the product. Make sure
that you have enough space before you begin with the assembly. We recommend assem-
bling the equipment at the location that you will be using it.
ATTENTION! The transport should always be executed by two people.
All nuts and screws are brought in from the front to back - with the nut on the backside.
Two persons are required for a few assembly steps.
To Next Page
Loading...
Need help?
General
