6-2
OPERATING PROCEDURES
Models 345, 346, 349, 355 NPR
Operating Procedures
6
WARNING! This machine has many sharp
edges that can cause severe injuries.
• DO NOT put objects or fingers in the door
spout. This may contaminate the product and
cause severe personal injury from blade
contact.
• USE EXTREME CAUTION when removing the
beater assembly. The scraper blades are very
sharp.
3. Before installing the beater assembly, check the
scraper blades for any signs of wear or damage. If a
scraper blade is nicked or worn, replace both blades.
Figure 6-3
4. If the blades are in good condition, place the rear
scraper blade over the single holding pin on the
beater (knife edge to the outside). Holding the blade
on the beater, turn it over and install the front blade
the same way.
Figure 6-4
5. Holding the blades in position, insert the beater
assembly into the freezing cylinder and slide it into
position over the driveshaft. Turn the beater slightly
to make sure that the beater is properly seated.
When in position, the beater will not protrude beyond
the front of the freezing cylinder.
Figure 6-5
6. Install the white, plastic guide bearing on the short
end of the baffle assembly. Slide the O-ring into the
groove on the long end of the baffle assembly and
lubricate the O-ring. Do not lubricate the guide
bearing.
Figure 6-6
7. Insert the short end of the baffle assembly into the
pilot hole in the center of the driveshaft. The hole in
the baffle assembly should be rotated to the 12
o’clock position.
8. Before assembling the freezer door, check the
following for any nicks, cracks, or signs of wear: front
bearing, door gasket, draw valve, O-rings, and all
sides of the door assembly, including the inside of the
draw valve bore. Replace any damaged parts.
11120
Apply the appropriate
Taylor approved food safe lubricant.
HP
To Next Page
Loading...