OPERATING PROCEDURES
6-3
Models 345, 346, 349, 355 NPR
Operating Procedures
6
9. Install the O-rings on the draw valve and lubricate.
Figure 6-7
10. Turn the door upside down. Insert the draw valve
spring.
Figure 6-8
11. Insert the draw valve into the door. Line up the small
hole on each side of the draw valve with the slot on
each side of the door spout.
Figure 6-9
12. Apply firm downward pressure on the draw valve and
center the draw valve hole in the small slot on the left
side of the spout. Insert the draw valve handle
through the slot and into the draw valve hole.
Figure 6-10
13. Move the draw handle to the forward position to allow
installation of the ice buster.
Figure 6-11
101305
Apply the appropriate
Taylor approved food safe lubricant.
HP
To Next Page
Loading...