6-4
OPERATING PROCEDURES
Models 345, 346, 349, 355 NPR
Operating Procedures
6
14. From the back of the door, install the ice buster
through the door spout and into the slot located just
above the lower O-ring.
Figure 6-12
15. Move the draw handle to the back position to lock the
ice buster in place.
Figure 6-13
16. Turn the door right-side up. Remove the draw valve
handle. Install it on the other side through the longer
slot and into the draw valve hole.
Figure 6-14
17. Insert the valve handle pin. Turn the pin and the draw
valve handle until the pin drops completely into place.
Note: While turning the draw valve handle, it may
be necessary to pull the draw valve handle back
slightly to allow the pin to fall in place.
Figure 6-15
To Next Page
Loading...